Perfect Popovers (2024)

FAQs

What is the secret to good popovers? ›

My biggest tip for creating perfect popovers is to use warm milk and room-temperature eggs with absolutely no chill on them. Do not take the milk and eggs from the fridge and use them. Cold ingredients will give you dense popovers. Warm ingredients will give you light, airy, and perfect popovers.

There can be a few different things that can mess up the rise of popovers. Preheat the oven to 425 with the pan preheating in the oven. When baking don't open it again until they're done. If you open the oven door the temperature inside can drop too quickly and the popovers will not rise properly.

The flour needs some time to absorb into the liquid, which not only thickens the batter a bit, it also allows the gluten molecules to relax which makes for a lighter, not chewy popover. The resting period also makes the batter more velvety and helps allow air bubbles to release.

Preheating your oven to the correct temperature is probably the most important thing you can do to ensure popover success. The hotter your oven, the higher your popovers will rise. Which makes sense: the faster liquid in the batter turns into steam, the more chance your popover has to expand before its crust sets.

Best to use all warm ingredients in the 40-50 degrees celsius (100-120 fahrenheit) range. There are two major possible causes that seem likely: The oven was not hot enough. Popovers require a fast rise, so that they can expand from the steam before the outside sets.

Make the batter in a blender; make it with a whisk. Beat till smooth and frothy; leave some lumps. Everything should be at room temperature. Everything should be lukewarm.

Remove from oven:

Popovers lose their crunch if they linger in the pan, so turn them out on a wire rack immediately and poke a small opening in the side of each with a paring knife to let the steam escape. Serve right away.

And be sure to grease not only the cups, but the surface around them as well. The popovers are going to balloon up and over the edges of the wells. Fill the cups about 2/3 to 3/4 full. Put the pan in the oven, on a lower rack.

An additional trick for keeping popovers crisp is to gently poke a hole in the side of each one with a sharp knife when you remove it from the pan to allow extra team to escape without deflating the crust dome.

Seeking Optimal Lift and Crispness

Not only were popovers made with bread flour about 30 percent taller than those made with all-purpose flour, but their higher walls were also thinner, making them a bit more crisp, and that crispness held up as they cooled. Bread flour was in. Next up: the milk.

Should a popover have a close button? ›

Ideally, a popover doesn't cover the element that revealed it or any essential content people may need to see while using it. Use a Close button for confirmation and guidance only. A Close button, including Cancel or Done, is worth including if it provides clarity, like exiting with or without saving changes.

Now you can open the oven door and check the popovers. Finished popovers will be golden-brown, feel dry to the touch, and sound hollow when tapped. Prick with a Knife, Cool, and Eat!: Turn the popovers out onto a drying rack. Pierce the bottoms with a knife to allow steam to escape.

The keys to baking popovers are to use a high oven temperature (I prefer 425° F) and to not disturb them (by opening the oven) during the process. I know, I know—I like to peek in on my baked goods, too. But this is one time you really should try to resist.

If your popovers lose volume when they come out of the oven, they are probably underbaked. When these airy baked goods aren't cooked enough, too much steam stays trapped inside. That moisture condenses once they're removed from the oven, causing them to collapse.

Dense popovers (either from not rising or not getting nice hollows inside) can result from a couple things but usually it is by either not starting with room temperature eggs and milk, not preheating the popover pan, not using a quality popover tin, and/or making too thick of a batter.